Saving / backing up Path Rules

Having problems with or questions about SheetCam? Post them here.
Post Reply
mancavedweller
Posts: 161
Joined: Tue Feb 25, 2014 6:53 am

Saving / backing up Path Rules

Post by mancavedweller »

Do we have any way to back up Path Rules so on a new install of Sheetcam we don't have to write them all over again ?

Keith
User avatar
Les Newell
Site Admin
Posts: 3661
Joined: Thu May 11, 2006 8:12 pm

Re: Saving / backing up Path Rules

Post by Les Newell »

Rules are saved with the job file. Save a job then load it into the new copy of SheetCam. That will also copy your tools.
Another option is to copy the settings file. Go to Help->open settings folder. Copy the ini file and tools to a USB drive. On the new computer run SheetCam and go to Help->open settings folder. Close SheetCam, leaving the settings folder open. Now copy your files across. If you have a custom post, you can copy that at the same time.
mancavedweller
Posts: 161
Joined: Tue Feb 25, 2014 6:53 am

Re: Saving / backing up Path Rules

Post by mancavedweller »

That's great, thanks Les.

Keith.
Post Reply