Scanything and Pokeys
Posted: Sun May 12, 2019 8:56 am
Hi
I am using Scanything with Mach3 and PokeysCnc57. I am having problems when trying to jog in the X axis. It would seem that I can only travel in one direction and only the master(not slave) motor is turning. All movement on the X axis is always in one direction no matter the direction of the request.
Any suggestions please?
I am using Scanything with Mach3 and PokeysCnc57. I am having problems when trying to jog in the X axis. It would seem that I can only travel in one direction and only the master(not slave) motor is turning. All movement on the X axis is always in one direction no matter the direction of the request.
Any suggestions please?