I am new to all of this. Just bought a plasma table and all software and licenses were supposed to be included. However, when I try to Post Process I keep getting the following error.
Post processing...
Part:Fart Just For You
Outside Offset, 1, T15: thin mild steel
Error: Evaluation limit reached
Post processing failed
Is this due to a licensing issue? Will I need to purchase a license? Is this due to where I bought the plasma table from not purchasing a license for my computer?
License Issue
- Les Newell
- Site Admin
- Posts: 3661
- Joined: Thu May 11, 2006 8:12 pm
Re: License Issue
That message means your license is not installed. I'd recommend contacting your machine supplier and asking them for a coy of the license.