Trying to use sheetcam with an older ESAB Sabre 2000

Having problems with or questions about SheetCam? Post them here.
Post Reply
NickThe1Rebel
Posts: 1
Joined: Fri Apr 05, 2019 5:24 pm

Trying to use sheetcam with an older ESAB Sabre 2000

Post by NickThe1Rebel »

Hello, I am trying to make Sheetcam work with an old Esab sabre 2000 and I can't seem to get the post processor set up correctly. I am using ESAB ESSI and have it exporting in .mpg but when I put the floppy disk in the table's computer it says there's a format error and will not open the file. I'm pretty new to all of this stuff so any help would be greatly appreciated. Thank you in advance!
User avatar
djreiswig
Posts: 471
Joined: Sat Feb 20, 2016 4:47 am
Location: SE Nebraska

Re: Trying to use sheetcam with an older ESAB Sabre 2000

Post by djreiswig »

If you have a working gcode file that shows the proper format for your machine, you can make the post do almost anything. I'm not familiar with esab machines, so I wouldn't be much help without an example.
Post Reply