Page 1 of 1
Update to sheetcam
Posted: Fri Dec 28, 2018 9:26 pm
by Weldude
I have a burntables brand plasma table that’s two years old. Never have done update. How do I get the update ?
Re: Update to sheetcam
Posted: Sat Dec 29, 2018 1:29 am
by djreiswig
SheetCam should prompt you to download updates. If not, you can go to the website and download it from there.
Re: Update to sheetcam
Posted: Sun May 19, 2019 11:26 pm
by pgilley
Rather old post. Just happened to see it and realized that I had the same problem and found that if you click on HELP in Sheetcam there is an place for checking and updating Sheetcam.