Top of Part Vs Bottom of Part

Having problems with or questions about SheetCam? Post them here.
Post Reply
skimann20
Posts: 1
Joined: Thu Dec 20, 2018 2:18 pm

Top of Part Vs Bottom of Part

Post by skimann20 »

I've got an "easy" one.

I'm cutting material that is 1.47mm thick and when i generate the Gcode it thinks that the top of the part is 0 (i think). The reason i think this is when i run the Gcode on the CNC when the drag knife does the cutting it goes to -1.47. How do i change sheet cam so the bottom of part is at 0?

I appreciate the help.
Post Reply