Safe z

Having problems with or questions about SheetCam? Post them here.
Post Reply
Rad
Posts: 2
Joined: Sun May 14, 2017 12:53 am

Safe z

Post by Rad »

I have forgotten what settings i used to bring my z axis up at the End of my plasma cutting. I had set it this way to clear tip ups of cut pieces when returning to 0, 0.

I now now need to disable this setting or reduce how high the z axis travels up at the end of the cut, since i am cutting a job that is high above my slats and closer to the gantry and just don't have enough travel for my z axis to retract up. I am using uccnc with sheetcam.

Please help.
User avatar
Les Newell
Site Admin
Posts: 3661
Joined: Thu May 11, 2006 8:12 pm

Re: Safe z

Post by Les Newell »

Take a look in Options->job options->parking. You probably have a Z position specified there.
Rad
Posts: 2
Joined: Sun May 14, 2017 12:53 am

Re: Safe z

Post by Rad »

Thanks Les, will check that out
Post Reply