start points in holes

Having problems with or questions about SheetCam? Post them here.
Post Reply
rikduk
Posts: 47
Joined: Fri Oct 25, 2013 11:48 pm

start points in holes

Post by rikduk »

Hello, i use sheetcam for plasma cutting, and when i load operations on a part with holes, they all start in
the same direction. Is there a way for a part with multiple holes, that all starting points face the center point of the part?
I use layers for holes and usually use templates for efficiency

I do that so that the plasma nozzle gets worn evenly

thank you

Richard
Post Reply