No holes were found

Having problems with or questions about SheetCam? Post them here.
Post Reply
dennisshaw
Posts: 20
Joined: Fri May 13, 2016 1:01 pm
Location: South Yorkshire

No holes were found

Post by dennisshaw »

After importing drawing, setting up operation and running simulation everything runs fine, save job, save part, run post processor and save g/code.close job and save, open same job and get error message (NO HOLES WERE
FOUND), this as happened pretty regular over the last 3 years.
Problem is it means starting all over again importing drawing etc., and also when opening a part for Nesting, there are no Drill Holes, as any one found a fix for this Bug.
Attachments
Capture.PNG
Capture.PNG (32.72 KiB) Viewed 920 times
User avatar
Les Newell
Site Admin
Posts: 3661
Joined: Thu May 11, 2006 8:12 pm

Re: No holes were found

Post by Les Newell »

Thanks for the file you sent me. I can see the fault here and am working on fixing it. I can't believe how long this bug has been there :oops: It slipped though my net because it only appears on the release versions. It does not show up on my debug versions.
cohippy
Posts: 12
Joined: Tue Sep 06, 2016 8:27 am

Re: No holes were found

Post by cohippy »

Sorry to bump old thread I had this problem the 1 time I tried and gave up on it....for plasma process to centerpunch dill holes....is this issue fixed? I'm running the newest unstable release. Thank you
User avatar
Les Newell
Site Admin
Posts: 3661
Joined: Thu May 11, 2006 8:12 pm

Re: No holes were found

Post by Les Newell »

Yes it should be fixed. Let me know if you have any issues.
Post Reply