Finish allowance on spiral pocket over cut
Posted: Sun Jun 03, 2018 6:17 am
Hi Les
I used the finish allowance feature on a spiral pocket cut and found that the allowance caused the an over cut of the same size. It does show correctly on screen but the on the part it comes out wrong. I tried a negative number and that shows up as over cut on the screen but I did not cut a part with that setting as I know it works. I use it a lot to over cut a tight fitting part.
Look at the first part in the job.
I used the finish allowance feature on a spiral pocket cut and found that the allowance caused the an over cut of the same size. It does show correctly on screen but the on the part it comes out wrong. I tried a negative number and that shows up as over cut on the screen but I did not cut a part with that setting as I know it works. I use it a lot to over cut a tight fitting part.
Look at the first part in the job.