Toolbar layout
Posted: Sun May 13, 2018 8:43 pm
Post by machinist 1 on ยป Sun May 13, 2018 8:37 pm
Les I just purchaced purchased a new licence for Linux tng and i was wanting to know if there is a trick to saving your own custom toolbar layout , when i exit out of sheetcam and reopen the program the toolbar layout goes back to factory settings , thanks for your time
Les I just purchaced purchased a new licence for Linux tng and i was wanting to know if there is a trick to saving your own custom toolbar layout , when i exit out of sheetcam and reopen the program the toolbar layout goes back to factory settings , thanks for your time