Toolbar layout

Having problems with or questions about SheetCam? Post them here.
Post Reply
machinist 1 on
Posts: 12
Joined: Mon Nov 07, 2016 6:41 pm

Toolbar layout

Post by machinist 1 on »

Post by machinist 1 on » Sun May 13, 2018 8:37 pm

Les I just purchaced purchased a new licence for Linux tng and i was wanting to know if there is a trick to saving your own custom toolbar layout , when i exit out of sheetcam and reopen the program the toolbar layout goes back to factory settings , thanks for your time
Post Reply