Hole only cutting lead in
Posted: Tue May 01, 2018 6:56 am
Hello
everyone I'm new to this forum and new to Sheetcam.
Maybe someone can help
I'm using a DIY plasma table with Mach3
I have attached 2 Job files, one called 'zbrackets' when I run it on the machine, it comes to cutting the hole it only cuts the lead in.
However the second file 'hole16thc' works perfectly.
I can't just see what is wrong.
everyone I'm new to this forum and new to Sheetcam.
Maybe someone can help
I'm using a DIY plasma table with Mach3
I have attached 2 Job files, one called 'zbrackets' when I run it on the machine, it comes to cutting the hole it only cuts the lead in.
However the second file 'hole16thc' works perfectly.
I can't just see what is wrong.