Q regarding lead-in and open line

Having problems with or questions about SheetCam? Post them here.
Post Reply
motoguy
Posts: 121
Joined: Sun May 01, 2016 12:02 am

Q regarding lead-in and open line

Post by motoguy »

If a lead-in is selected with an open line, does sheetcam ignore the lead-in (with a "can't fit to path" error), or will it elongate the open line by the lead-in amount?

I know it will extend an open-line cut with an overcut, but now sure how it handles the lead-in/lead-out in that situation.

Thanks.
User avatar
djreiswig
Posts: 471
Joined: Sat Feb 20, 2016 4:47 am
Location: SE Nebraska

Re: Q regarding lead-in and open line

Post by djreiswig »

I think it would depend on the "Leadins on open paths" setting.
motoguy
Posts: 121
Joined: Sun May 01, 2016 12:02 am

Re: Q regarding lead-in and open line

Post by motoguy »

djreiswig wrote: Sun Apr 08, 2018 7:24 pm I think it would depend on the "Leadins on open paths" setting.
Well, that's embarrassing. I never even noticed that checkbox before!
User avatar
djreiswig
Posts: 471
Joined: Sat Feb 20, 2016 4:47 am
Location: SE Nebraska

Re: Q regarding lead-in and open line

Post by djreiswig »

It happens to the best of us. :mrgreen:
Post Reply