sheetcam.com

Hi Les,

Just wondering is there a reason why it's not possible?
It would be really useful if that was the case, all other modes you can add/edit operations.

Thanks
Sean

No problem if not, keep wondering about this though nearly every time time I use sheetcam.

The problem is that each part has it's own set of operations. In Nesting mode you can select more than one part. I supose I could allow editing operations as long as you only have one part selected.

That would be great if you could Les, I'm sure there would be a good few others happy as well if it's possible.

Many thanks.