Page 1 of 1
Edit operation while in nesting mode
Posted: Tue Apr 03, 2018 9:51 am
by SeanP
Hi Les,
Just wondering is there a reason why it's not possible?
It would be really useful if that was the case, all other modes you can add/edit operations.
Thanks
Sean
Re: Edit operation while in nesting mode
Posted: Sun Apr 08, 2018 11:18 am
by SeanP
No problem if not, keep wondering about this though nearly every time time I use sheetcam.
Re: Edit operation while in nesting mode
Posted: Mon Apr 09, 2018 3:49 pm
by Les Newell
The problem is that each part has it's own set of operations. In Nesting mode you can select more than one part. I supose I could allow editing operations as long as you only have one part selected.
Re: Edit operation while in nesting mode
Posted: Mon Apr 09, 2018 3:54 pm
by SeanP
That would be great if you could Les, I'm sure there would be a good few others happy as well if it's possible.
Many thanks.