Page 1 of 1

rotary template

Posted: Thu Mar 29, 2018 4:29 pm
by dhelfter
Is it possible to have the output from the rotary plugin dxf template in imperial instead of metric?
I know I can scale it in cad by 0.03937 but would be nice to output in inches.

Thanks
Dan

Re: rotary template

Posted: Tue Apr 03, 2018 12:24 pm
by Les Newell
That should happen automatically. Is SheetCam set to use inch units?

Re: rotary template

Posted: Tue Apr 03, 2018 12:38 pm
by Les Newell
I just ran some tests and in inch mode it is multiplying the dimensions by 25.4 instead of dividing them. I'll release an update shortly.

Re: rotary template

Posted: Wed Apr 04, 2018 10:44 pm
by dhelfter
sorry for delay.
That would make sense, when I bring the dxf in autocad I have to scale it twice by 0.03937 to get to incjes.

Thanks

Re: rotary template

Posted: Fri May 18, 2018 12:35 pm
by dhelfter
any progress on an update for inch templates?

Thanks