Failed Measuring Delay (15) error on scananything

Having problems with or questions about SheetCam? Post them here.
Post Reply
Jim A.
Posts: 3
Joined: Tue Apr 18, 2017 5:25 pm

Failed Measuring Delay (15) error on scananything

Post by Jim A. »

I am trying to get scan anything set up to run and I get this error when I calibrate. Failed Measuring Delay (15) is what shows up. I get the blue circle and the green circle and they will line up, but has to restart because of this error. Any ideas? Thanks in advance.
User avatar
Les Newell
Site Admin
Posts: 3661
Joined: Thu May 11, 2006 8:12 pm

Re: Failed Measuring Delay (15) error on scananything

Post by Les Newell »

Is this the Linux version or the Windows version?
Jim A.
Posts: 3
Joined: Tue Apr 18, 2017 5:25 pm

Re: Failed Measuring Delay (15) error on scananything

Post by Jim A. »

Linux using with Command CNC.
User avatar
Les Newell
Site Admin
Posts: 3661
Joined: Thu May 11, 2006 8:12 pm

Re: Failed Measuring Delay (15) error on scananything

Post by Les Newell »

It is failing to see the dot as it moves left<>right. Switch to mask mode and run the calibration again. Can you clearly see the dot moving as it calibrates? You may need to experiment with the brightness slider to get the clearest image.
Jim A.
Posts: 3
Joined: Tue Apr 18, 2017 5:25 pm

Re: Failed Measuring Delay (15) error on scananything

Post by Jim A. »

Thanks, I guess I was not patient enough.
Post Reply