Using sheetcam with grinding disc tool

Having problems with or questions about SheetCam? Post them here.
Post Reply
tony
Posts: 15
Joined: Sat Feb 24, 2018 1:36 pm

Using sheetcam with grinding disc tool

Post by tony »

Hello
I am using the sheetcam for a cnc engraving glass 4 axis
With a grinding & polishing disc tool, i am facing a problem that the corner are overlapping ( the line is extended) i was trying to make a negative offset on the lead in/out window but it doesn’t work, is there is any solutions for this problem like setup a v curve tool or editing the post processor(mach3 V2 tangential) to make offset on the current & end point (X,Y)
Thank u in advance
tony
Posts: 15
Joined: Sat Feb 24, 2018 1:36 pm

Re: Using sheetcam with grinding disc tool

Post by tony »

does anyone setup a disc tool?
User avatar
Les Newell
Site Admin
Posts: 3660
Joined: Thu May 11, 2006 8:12 pm

Re: Using sheetcam with grinding disc tool

Post by Les Newell »

Give this post a try.
Attachments
Glass cutter.scpost
(12.35 KiB) Downloaded 94 times
tony
Posts: 15
Joined: Sat Feb 24, 2018 1:36 pm

Re: Using sheetcam with grinding disc tool

Post by tony »

Les Newell wrote: Mon Feb 26, 2018 2:18 pm Give this post a try.

thank u Less
Post Reply