Hello
I am using the sheetcam for a cnc engraving glass 4 axis
With a grinding & polishing disc tool, i am facing a problem that the corner are overlapping ( the line is extended) i was trying to make a negative offset on the lead in/out window but it doesn’t work, is there is any solutions for this problem like setup a v curve tool or editing the post processor(mach3 V2 tangential) to make offset on the current & end point (X,Y)
Thank u in advance
Using sheetcam with grinding disc tool
Re: Using sheetcam with grinding disc tool
does anyone setup a disc tool?
- Les Newell
- Site Admin
- Posts: 3668
- Joined: Thu May 11, 2006 8:12 pm
Re: Using sheetcam with grinding disc tool
Give this post a try.
- Attachments
-
- Glass cutter.scpost
- (12.35 KiB) Downloaded 95 times
Re: Using sheetcam with grinding disc tool
thank u Less