Lead settings location

Having problems with or questions about SheetCam? Post them here.
Post Reply
User avatar
djreiswig
Posts: 471
Joined: Sat Feb 20, 2016 4:47 am
Location: SE Nebraska

Lead settings location

Post by djreiswig »

I know I asked this before, but I ran into it again yesterday. Shouldn't the lead in settings be in the tool settings, since the lead in is usually based on the material thickness. My situation was with my scribe. I have to turn off the leads when I scribe but then remember to turn them back on when I cut. With my scribe I never want to have a lead. It would be nice to be able to turn it off with the tool. Maybe there could be a selectable option to make it one way or the other.
Post Reply