Problem with Development version screen

Having problems with or questions about SheetCam? Post them here.
Post Reply
David Morrow
Posts: 14
Joined: Sat Nov 21, 2015 7:53 pm
Location: Vancouver, BC

Problem with Development version screen

Post by David Morrow »

I have been tinkering with the Development version and have set it up exactly the same as my stable version. But something is amiss here. See them side by side ( Dev version on the left ).
Attachments
Sheetcam screens (Small).jpg
Sheetcam screens (Small).jpg (99.8 KiB) Viewed 996 times
User avatar
Les Newell
Site Admin
Posts: 3661
Joined: Thu May 11, 2006 8:12 pm

Post by Les Newell »

Check your drawing import options are the same. Look in Options->application options->drawing import. You need to reload the drawing for any changes to take effect.
David Morrow
Posts: 14
Joined: Sat Nov 21, 2015 7:53 pm
Location: Vancouver, BC

Post by David Morrow »

I figured it out.

Even though in the Application Options I had the Units set for Inch, when I imported the file again, I noticed that the Scaling there was set for metric.
Post Reply