Scriber settings

Having problems with or questions about SheetCam? Post them here.
Post Reply
machinist 1 on
Posts: 12
Joined: Mon Nov 07, 2016 6:41 pm

Scriber settings

Post by machinist 1 on »

How are you Les , i am running Candcnc's commandcnc and i was wondering if you could help me set up my scribe so the cylinder would stay down and the scribe stay on the entire scribe cycle and only the z axis move up and down .This is how Wolfsmetalfab has his set up and seems to work the best that I have seen. He has a video on Yootube if you would like to view for a better explanation of the process,thanks for your time.
User avatar
Les Newell
Site Admin
Posts: 3661
Joined: Thu May 11, 2006 8:12 pm

Post by Les Newell »

What post processor are you using?
machinist 1 on
Posts: 12
Joined: Mon Nov 07, 2016 6:41 pm

Scriber settins

Post by machinist 1 on »

CandCNCPlasmallcnc-23(Edited)
machinist 1 on
Posts: 12
Joined: Mon Nov 07, 2016 6:41 pm

Scriber settings

Post by machinist 1 on »

CandCNCPlasmaLLCNC-rev23(Edited)
User avatar
Les Newell
Site Admin
Posts: 3661
Joined: Thu May 11, 2006 8:12 pm

Post by Les Newell »

I don't have that post. Could you send me a copy.
machinist 1 on
Posts: 12
Joined: Mon Nov 07, 2016 6:41 pm

Post by machinist 1 on »

Here you go Les ,thanks
Attachments
CandCNCPlasmaLLCNC-rev23.scpost
(34.61 KiB) Downloaded 98 times
CandCNCPlasmaLLCNC-rev23.scpost
(34.61 KiB) Downloaded 76 times
User avatar
Les Newell
Site Admin
Posts: 3661
Joined: Thu May 11, 2006 8:12 pm

Post by Les Newell »

Give this a try. I hate messing with CandCNC posts. They are very complicated and it is difficult to make changes and be sure you aren't affecting some other part of the code.
Attachments
CandCNCPlasmaLLCNC-rev23-marker on.scpost
(34.7 KiB) Downloaded 131 times
machinist 1 on
Posts: 12
Joined: Mon Nov 07, 2016 6:41 pm

Scriber settings

Post by machinist 1 on »

Sure will , i will let you know how it goes , thanks
machinist 1 on
Posts: 12
Joined: Mon Nov 07, 2016 6:41 pm

Scriber settings

Post by machinist 1 on »

I just tried it Les and it doesn't seem to be adding the offsets to the code
Post Reply