Bug with Code Snippits

Having problems with or questions about SheetCam? Post them here.
Post Reply
jeffery71
Posts: 22
Joined: Fri Dec 30, 2016 10:19 am

Bug with Code Snippits

Post by jeffery71 »

Hi Les,

There appears to be a bug with code snippets.. Both in the released version and the developmental version.

If you create a part file with a code snippet under cutting operations. Then later try to remove the code snippet by selecting "None" on the Cutting operations screen. It does not remove the code snippet from the part.
It will show up as "None" in the cutting operation. But when posting it the code snippet will show up in the gcode

Attached is a sample job file.
Attachments
SquareTest.job
(10.37 KiB) Downloaded 89 times
jim1108
Posts: 74
Joined: Sat Oct 29, 2016 1:19 pm
Location: New Mexico, USA

Snippets

Post by jim1108 »

I have run into the same problem. I understand it staying with the tool library, but it seems to stay there even if you only put it in the operation for a specific job.
User avatar
Les Newell
Site Admin
Posts: 3661
Joined: Thu May 11, 2006 8:12 pm

Post by Les Newell »

You have a snippet assigned to your start point. Switch to start point mode, right-click on the start point and select 'properties'. You need to disable the snippet in there.
jeffery71
Posts: 22
Joined: Fri Dec 30, 2016 10:19 am

Post by jeffery71 »

Oh wow I didn't even notice you could put snippets on individual start points! I wonder how I managed to do that!

Thanks!!
Post Reply