If you have a problem with Fanuc Rigid Tapping

Having problems with or questions about SheetCam? Post them here.
Post Reply
jim1108
Posts: 74
Joined: Sat Oct 29, 2016 1:19 pm
Location: New Mexico, USA

If you have a problem with Fanuc Rigid Tapping

Post by jim1108 »

Here is an edited Fanuc post that fixed a rigid tap problem in the original where the machine would just stop and do nothing after positioning at the hole. You can compare the original with my edited version noting the Daewoo 6025s machine. This machine accepts G84 canned cycle as well, but has to be preceded by M29 and the speed.
Attachments
Fanuc.scpost
(6.27 KiB) Downloaded 183 times
Post Reply