Loops on corners with path rules

Having problems with or questions about SheetCam? Post them here.
Post Reply
SeanP
Posts: 217
Joined: Wed Oct 23, 2013 9:50 am

Loops on corners with path rules

Post by SeanP »

Just noticed this one this morning, I sometimes need to add a little slowdown at the cross over of the lead in to get the part to drop out when cutting 12mm on my machine, the rules are great for this.

However I noticed adding loops on corners seems to stop the 50% reduced feedrate rule from running.

Any ideas?
Attachments
Loops off.jpg
Loops off.jpg (143.45 KiB) Viewed 1903 times
Loops on.jpg
Loops on.jpg (148.33 KiB) Viewed 1903 times
SeanP
Posts: 217
Joined: Wed Oct 23, 2013 9:50 am

Post by SeanP »

Ah sorry ignore that, opened another job using same toolset/rules and it's ok now :oops:
SeanP
Posts: 217
Joined: Wed Oct 23, 2013 9:50 am

Post by SeanP »

Ah so maybe there was something, I see it listed in the development version recent change list, many thanks, it did crop up again since.
Post Reply