linuxcnc probotix and THCsd

Having problems with or questions about SheetCam? Post them here.
Post Reply
sawdust
Posts: 10
Joined: Mon Dec 28, 2015 9:29 am

linuxcnc probotix and THCsd

Post by sawdust »

My mind is going, not sure if I posted this or just thought about it.

Upgraded linux added wine, sheetcam tng and it works beautifully.

Put in the Proma sd. As long as I leave the THC unpowered the slgnal flows through and everything is good. When I put power to the THC it suddenly runs the z axis down. I am using a battery for clean power,( that was an issue my friend had with his Proma THC).

ANy thoughts?

david
Post Reply