I am having problems with the setup of a textile cuttter using the Mach 3 Tangenial 3 head post.
I created the init.tap file like this.
Code: Select all
;offsets for tools 100-199
#1 = 10 ;X
#2 = 1 ;Y
#3 = 100 ;Z
;offsets for tools 200-299
#4 = -10 ;X
#5 = -1 ;Y
#6 = -100 ;Z
;;;;;;;;;;You should not need to change any of this ;;;;;;;;;;;;
G54
G10 L2 P2 X[#5221 - #1] Y[#5222 - #2] Z[#5223 - #3]
G10 L2 P3 X[#5221 - #4] Y[#5222 - #5] Z[#5223 - #6]
And here is the first section of my code
Code: Select all
N0000 (Filename: AOuterProfile.tap)
N0010 (Post processor: Mach3 tangential with 3 heads.scpost)
N0020 (Date: 2012/12/12)
N0030 G91.1 (incremental IJ mode)
N0040 G21 (Units: Metric)
N0050 G53 G40 G90
N0060 F1000
N0070 M98 (init.tap)
N0080 (Part: AOuterProfile)
N0090 (Operation: No Offset, 0, T200: Pen, 0 mm Deep)
N0100 M6 T200 (Pen)
N0110 G43 H200
N0120 F100.0
N0130 G56
N0140 G00 X210.0 Y80.0