Page 1 of 1

Plasmatool Set for Razorweld Cut 45?

Posted: Tue Jul 20, 2021 2:20 pm
by omamed
Hi, Really quite new to sheetcam world. I'm looking here to see if there is a "Plasmatool" set for the Razorweld Cut 45. I see that there is one for the Hypertherm XP45. Does such a thing exist, or do I have to build one on my own. Assumed someone would post a set that they were using and I could tweak from there for my own setup. Thanks for entertaining the newb post!

Re: Plasmatool Set for Razorweld Cut 45?

Posted: Tue Jul 20, 2021 9:27 pm
by robertspark
https://forum.langmuirsystems.com/t/raz ... etcam/8921

https://forum.langmuirsystems.com/t/raz ... chart/1232

create your own, you will probably need to tweak it anyway to your setup but it will get you started.

(I use a hypertherm 45 non XP)

Re: Plasmatool Set for Razorweld Cut 45?

Posted: Mon Jun 20, 2022 3:26 pm
by omamed
So sorry not to have thanked you for your links... This was helpful on my journey into SheetCam and I appreciate the time you took to post a response! Have a great day! Otis