Page 1 of 1

errant Tangential blade motion

Posted: Tue Apr 26, 2016 8:54 am
by Garth
Good Day Les
I am getting a change in output on Mach3 DRO for the A axis( tangential Blade) on straight lines and possibly only 1-2 line segments in a complete drawing. But if I single step through the same G-code the output performs as expected and no random changes.
I will try and include the G -code and a section of the drawing the fun starts at the vertical line after line 1730 of the code.
Any suggestion to get to the bottom of this would be much appreciated.