sheetcam.com

Hi Steve,

I use the -c switch. Like this:

SheetCam TNG Development.exe -c plasma

This will create a directory "plasma" which holds it's own toolset and configuration file. Post processor file is still stored with all other post files, but the separate config file holds that info, too.

HTH
Paul

__._,_.___
Posted by: urbnsr@yahoo.com


Visit Your Group

• New Members 2

Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) • Terms of Use



__,_._,___

Yes, that is the correct way to do it. Here are some slightly more detailed instructions:

Make a copy of the shortcut to SheetCam and rename it. Right-click on the shortcut and select 'Properties'. In the 'Target' tab the Target should be something like this:
"C:\Program Files (x86)\SheetCam TNG\SheetCam TNG.exe"

To use a different profile change the target to:

"C:\Program Files (x86)\SheetCam TNG\SheetCam TNG.exe" -c myProfile

where myProfile is a name for the profile. The first time you use that shortcut it will copy your original SheetCam settings to the new profile. From then on any changes you make to that profile's settings will not affect any other profiles you have set up.

Les




On 12/05/2015 11:22, urbnsr@yahoo.com (urbnsr@yahoo.com) [sheetcam] wrote:

Hi Steve,

I use the -c switch. Like this:

SheetCam TNG Development.exe -c plasma

  This will create a directory "plasma" which holds it's own toolset and configuration file. Post processor file is still stored with all other post files, but the separate config file holds that info, too.

HTH
Paul

__._,_.___
Posted by: Les Newell <les.newell@fastmail.co.uk>


Visit Your Group

• New Members 2

Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) &bull; Terms of Use



__,_._,___

Thank you for the prompt replies! I'll have a go at it today!!

Steve


__._,_.___
Posted by: steve@adnaironworks.com


Visit Your Group

• New Members 2

Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) &bull; Terms of Use



__,_._,___

Thanks again Les! Works perfect!

Steve


__._,_.___
Posted by: steve@adnaironworks.com


Visit Your Group

• New Members 2

Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) &bull; Terms of Use



__,_._,___