Problem with feedrate - 60X too high

Posts redirected from the Yahoo mailing list
Post Reply [...

Problem with feedrate - 60X too high

Post by [... » Sat May 02, 2015 11:45 pm

I'm having a problem with the gcode that SheetCAM generates the F command is 60x higher than it should be. If feed rate for the tool is 2 IPS the F command says 120. I looked at some old gcode files that Sheetcam generated and they look correct. I'm using SheetCAM 5.0.1 on WinXP without a network. Its worked ok for a long time. Not sure what happened, but there are other users... Any ideas? Can I upgrade to latest and still run XP? Thanks,

Posted by:

Visit Your Group
Unsubscribe ([email][/email]) • Terms of Use


Post Reply