Sheetcam Post Processor

Posts redirected from the Yahoo mailing list
Post Reply
Les Newell les.newell@...

Sheetcam Post Processor

Post by Les Newell les.newell@... »

What controller does your cnc table use?


Les

On 26/02/2015 15:08, Kyle Van Leuven kvan31@yahoo.com (kvan31@yahoo.com) [sheetcam] wrote:
I recently bought a CNC table and the builder had it set up for cambam. I would prefer to use sheetcam. Is there any way to convert the cambam post processor to work in sheetcam? I tried directly importing but it did not work. 


I have attached the cambam post processor, and a gcode file that was made with it. 




__._,_.___
Posted by: Les Newell <les.newell@fastmail.co.uk>
Image

Visit Your Group
Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) &bull; Terms of Use



__,_._,___
Post Reply