TNG development V4.1.11 released

Posts redirected from the Yahoo mailing list
Post Reply
testcb

TNG development V4.1.11 released

Post by testcb »

Les,Thanks for the status update,

I was able to get SheetCam TNG V6.0.1 to install and startup using wine under OS-X.
I will need to do some further testing with some DXF files I have. I will post back later with my results.


Thanks again,
Curt



On Apr 18, 2014, at 11:35 AM, Les Newell <les.newell@fastmail.co.uk (les.newell@fastmail.co.uk)> wrote:

Hi Curt,

I am working on a new Linux version but I am afraid it is rather slow going. Do you have any luck using the Windows version under Wine?

Les

On 17/04/2014 19:00, testcb@cableone.net (testcb@cableone.net) wrote:
Hi Les, Looks like July 2012 it was the last update that I can find for SheetCAM TNG for Linux. Is there or is there going to be an update to this or is Linux a dead player? Our environment consists of Linux and OS-X only. Windows is out of the question, small shop and don't have the time support it.


Thanks for a great product.
Curt








__._,_.___
Image

Visit Your Group
Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) &bull; Terms of Use



__,_._,___
Scott V
Posts: 25
Joined: Fri May 12, 2006 6:37 am

Post by Scott V »

Looks like some Post processors are missing in this release. (V6.0.1) On my download anyway..


No big deal, because I added the one I needed..
Post Reply