Scanything won\'t run Mach3

Posts redirected from the Yahoo mailing list
Post Reply
Les Newell

Scanything won\'t run Mach3

Post by Les Newell »

Hi Brian,

Is your camera oriented correctly? When you jog right the view shoould move left. When you jog up the view should move down.

Les

On 14/03/2014 19:53, Brian Martin wrote:
Ok. I've been reinstalling some software and I got a response out of Scanything. Now it starts the calibration, finds its spot in the center, then in the bottom RH corner then it runs toward the top and just runs away! Thanks for any help.
I really think this is a great tool if I can get it to work!



__._,_.___
Image

Visit Your Group
Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) • Terms of Use



__,_._,___
Post Reply