Drag Knife-Job Template Issue

Posts redirected from the Yahoo mailing list
Post Reply
jleaders.2

Drag Knife-Job Template Issue

Post by jleaders.2 »

Hi Les,

Just wanted to let you know that currently when I try to save a job template that has a drag knife tool setup in it, I get the following message in a popup "This file format does not support KnifeTool". Didn't know if this is something that would need to be fixed.



Currently Using Development 5.1.30.


Regards, Jon


__._,_.___
Image

Visit Your Group

Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) • Terms of Use



__,_._,___
Les Newell

Drag Knife-Job Template Issue

Post by Les Newell »

Hi Jon,

Sorry about the delay in getting back to you. I have fixed this for the next release.

les

On 04/03/2014 22:27, jleaders.2@gmail.com (jleaders.2@gmail.com) wrote:
Hi Les,

Just wanted to let you know that currently when I try to save a job template that has a drag knife tool setup in it, I get the following message in a popup "This file format does not support KnifeTool".  Didn't know if this is something that would need to be fixed.



Currently Using Development 5.1.30.


Regards, Jon



__._,_.___
Image

Visit Your Group
Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) • Terms of Use



__,_._,___
Post Reply