TNF development version V5.1.29 released

Posts redirected from the Yahoo mailing list
Post Reply
Les Newell

TNF development version V5.1.29 released

Post by Les Newell »

Hi all,

I have just uploaded V5.1.29 to www.sheetcam.com

Fixed: Action tabs not working on a climb cut path
Fixed: Action tabs sometimes triggering an unwanted path rule
Changed: Mach plugin completely rewritten. Should now work with all
versions of Mach.
Fixed: Rotary plugin not handling path rules correctly when 'Show rules
in Gcode' is selected
Fixed: Suppport dialog crashing if it is called when SheetCam closes

The new Mach plugin now works completely differently. It uses a plugin
in Mach to establish a high speed communications link with SheetCam.
This gives much more control over Mach than the previous version did.
Note that you need to enable the SheetCamRemote plugin in Mach3. You can
do this by going to Config->Config plugins.

Les



------------------------------------

Yahoo Groups Links

<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/sheetcam/

<*> Your email settings:
Individual Email | Traditional

<*> To change settings online go to:
http://groups.yahoo.com/group/sheetcam/join
(Yahoo! ID required)

<*> To change settings via email:
sheetcam-digest@yahoogroups.com
sheetcam-fullfeatured@yahoogroups.com

<*> To unsubscribe from this group, send an email to:
sheetcam-unsubscribe@yahoogroups.com

<*> Your use of Yahoo Groups is subject to:
https://info.yahoo.com/legal/us/yahoo/utos/terms/
Post Reply