Page 1 of 1

Postprocessor

Posted: Mon Sep 03, 2007 7:26 am
by éÇÏÒØ âÉÒÍÁÎ
Dear Sirs

I'd want buy Your SheetCam in case if you'll make new postrocessor for Biesse Rover NC500
Please inform me about conditions

Best regards

Igor Birman

Postprocessor

Posted: Mon Sep 03, 2007 8:15 am
by LesNewell
Hi Igor,


Send me some samples of code and, if possible, a copy of the relevant
parts of the manual and I'll write a post for you. Send them to les {at}
sheetcam.com (replace the {at} with @).

Les

éÇÏÒØ âÉÒÍÁÎ wrote:
Dear Sirs

I'd want buy Your SheetCam in case if you'll make new postrocessor for Biesse Rover NC500
Please inform me about conditions

Best regards

Igor Birman

Re: Postprocessor

Posted: Thu Sep 10, 2020 6:12 pm
by TRUE LIFESTILE
We have had this software for acouple years and have not been having any luck getting our machine to read any posts.
Biesse does not work on 3rd party software posts and cant help

Is anyone able to help us, we are wanting to use a draw knife to cut vinyl