Hey guys thanks in advance for any help!
My last machine would finish the cut and raise the torch to rapid clearance height and just stop right there. My new one finishes the cut and raises to rapid clearance height and goes back to x0 y0. I don’t like it that way because I prefer it to not go over what’s already been cut because of tip ups. What do i need to do to make it just stop where it’s at after the cut?
Look and see how you have parking set under the Job Options. I keep them all unchecked and it leaves the last cut at my safe Z.
It might also be hardcoded in the post processor. Look for G0 x0 y0 z0 in OnFinish.