shapeoko post processor

Hello i have been using sheetcam for my plasma table for 3 years and i love it (THANK YOU!!) So now i want to use it for my shapoko desktop mill but i don’t know what post processor to use any help here would be appreciated
http://www.shapeoko.com/wiki/index.php/Software


my cotroller http://arduino.cc/en/Main/arduinoBoardUno
http://docs.shapeoko.com/electronics.html



Thanks


.,._
Posted by: tomtorraville@yahoo.ca

Visit Your Group

Unsubscribe (<sheetcam-unsubscribe@yahoogroups.com>?subject=Unsubscribe) • Terms of Use



,.,_

Try the minimum g-code post. It should be pretty close.

Les

On 02/09/2014 01:55, tomtorraville@yahoo.ca (tomtorraville@yahoo.ca) [sheetcam] wrote:

Hello i have been using sheetcam for my plasma table for 3 years and i love it (THANK YOU!!) So now i want to use it for my shapoko desktop mill but i don’t know what post processor to use any help here would be appreciatedÂ
 > http://www.shapeoko.com/wiki/index.php/Software >


my cotroller > http://arduino.cc/en/Main/arduinoBoardUno >
http://docs.shapeoko.com/electronics.html



ThanksÂ
Â


.,._
Posted by: Les Newell <les.newell@fastmail.co.uk>

Visit Your Group

Unsubscribe (<sheetcam-unsubscribe@yahoogroups.com>?subject=Unsubscribe) • Terms of Use



,.,_

Hi tomtorraville,

did you have any success with your Shapeoko and GRBL and Sheetcam?

Andrew