Working on post for my plasma.
post.DefineCustomToolParam(“PlasmaTool”, “Preset volts”, “presetVolts”, sc.unit0DECPLACE, 49, 0, 200)
works correctly in that it shows up in the tool table and has values
but when I run my post the line:
post.Text (" # = ", presetVolts, “”)
always results in:
# = nil
I updated to the most recent versions and also tried some other posts that used customToolParams and they resulted the same with their values being nil
I am using sheetcam in a VM incase that makes a difference.
Anyone got any ideas? I am so close, if I get this post working I am complete with my build.
.,._
Posted by: rtavk311@yahoo.com
Unsubscribe (<sheetcam-unsubscribe@yahoogroups.com>?subject=Unsubscribe) • Terms of Use
,.,_