on my plasma table how do i put a path rule in sheet cam to know on hex holes to slow down and do a better job on the hex holes. every time i do hex holes it ends up being more of as circle then a hex hole.
I don’t believe there is a rule to apply for this use case given the very short straight runs before the 60* angle. I think it would be cleaner code and more fool proof if you put all the hex holes in a separate layer (do it in CAD) and just cut that layer with an Operations that overrides the tool feedrate. This way you are not editing the toolpath shapes in sheetcam.
If you prefer to edit shapes, you can use Mode-‘Action Point’ to place a Code Snippet tool which reduces feedrate, but that requires editing each hex hole.