Aligning Start points, Lead-ins/outs

Hi Folks,
Cutting an outside offset with tabs and arc lead-ins/outs. One rough path, .100" depth per pass through .500 material leaving .010 for clean-up.
Next path is finishing with the same tool at full depth.
Copied the tabs from rough to finish, (that’s neat).
Now, I want to move the start points for these two offsets to exactly the same spot. Looks like they will snap to any corner but I’d like to place them along a side of the profile. Is there a way to align them exactly, or is it just by eye ?

Thanks :slight_smile:

I am afraid it is just by eye at the moment. I’ll look into adding a ‘copy start points’ option.