Search found 3656 matches
- Tue Dec 11, 2012 3:45 pm
- Forum: New features
- Topic: let the cut be in the order that it is drawn.
- Replies: 1
- Views: 4009
- Tue Dec 11, 2012 3:43 pm
- Forum: Problems and questions
- Topic: Why doesn't SC recognize my holes sometimes?
- Replies: 15
- Views: 7185
- Sat Dec 08, 2012 10:39 pm
- Forum: Problems and questions
- Topic: Stop and start for tool change
- Replies: 1
- Views: 1440
In Mach3 go to Config->general config. You should find an option to stop on tool changes. You can put all of your drill holes on one layer. In each drill operation use min hole size and max hole size to select which holes to drill. Only circles between these two sizes will be drilled. If you are spo...
- Sat Dec 08, 2012 10:00 am
- Forum: Problems and questions
- Topic: Can I manually choose the order of cuts?
- Replies: 1
- Views: 1723
There are two ways of changing the cut order. In start point mode, right click on a start point and select 'properties'. You can then enter the number for that start point. Alternatively right-click and select 'auto cut sequence'. Now click on the start points in order. Right-click and select 'end s...
- Thu Dec 06, 2012 11:58 am
- Forum: Problems and questions
- Topic: picking midpoint of line for leadin
- Replies: 16
- Views: 7273
- Thu Dec 06, 2012 9:05 am
- Forum: Problems and questions
- Topic: picking midpoint of line for leadin
- Replies: 16
- Views: 7273
- Thu Nov 29, 2012 4:10 pm
- Forum: Problems and questions
- Topic: Can post access to information about cut direction
- Replies: 3
- Views: 1670
- Thu Nov 29, 2012 3:29 pm
- Forum: Problems and questions
- Topic: Can post access to information about cut direction
- Replies: 3
- Views: 1670
- Tue Nov 27, 2012 5:44 pm
- Forum: Problems and questions
- Topic: New Install, Black Screen
- Replies: 31
- Views: 13974
- Wed Nov 21, 2012 10:33 am
- Forum: Problems and questions
- Topic: Which PP to use ?
- Replies: 4
- Views: 2363
- Wed Nov 21, 2012 10:29 am
- Forum: Problems and questions
- Topic: can not save tool paths
- Replies: 4
- Views: 2278
Open contours are a special case when offsetting. Open paths are always offset to the right. Imigine you are stood on the start of the line, looking along it. The offset will always be to your right. To reverse the offset move the start point to the other end of the line. To do this go to Mode->edit...
- Mon Nov 19, 2012 2:59 pm
- Forum: Problems and questions
- Topic: Which PP to use ?
- Replies: 4
- Views: 2363
- Sat Nov 17, 2012 9:40 pm
- Forum: Problems and questions
- Topic: Looking for Mach3 Post Processor
- Replies: 3
- Views: 2518
- Sat Nov 17, 2012 9:32 pm
- Forum: Problems and questions
- Topic: Looking for Mach3 Post Processor
- Replies: 3
- Views: 2518
- Thu Nov 15, 2012 10:29 am
- Forum: Problems and questions
- Topic: New Install, Black Screen
- Replies: 31
- Views: 13974