sheetcam.com

I have other files on same drive that work. Also cannot connect to update server. The Sheetcam version I am using is a rather old version. 6.0.30 version

This problem is happening for some files and not others. The message I receive from Sheetcam when this happens is:
An unexpected error has occurred :
Unable to open output file F\Julia1.tap
This error occurred on line 1197 in file ..
\Comlib\postmacro.cpp)
Post processing failed

cannot connect to sheetcam update server.

Have done that. When reopen sheetcam the tools are back on.

I have several unused tools on sheetcam. Would like to permanently remove them. Anyone have directions to do this ?

Rather old post. Just happened to see it and realized that I had the same problem and found that if you click on HELP in Sheetcam there is an place for checking and updating Sheetcam.

Thanks for the reply. I will change the pierce delay and see. I did not do any of the drawing on this file. Came from a dxf file from a friend. When I initially cut this pattern it worked great. Just started doing some of the weird stuff after quiet some time of use. Over time I had cut several of t...

Anyone using the Esab Cutmaster 60i on a plasma table ? I am using a Cutmaster 52 (Radnor version) and the duty cycle shuts down at times. Some cuts run about 20 minutes. Just wondering if my 1Torch on the 52 will work on the 60i ? I am using the 1Torch hand torch wired directly to the trigger switc...

Not very good with PC. Will try to send file.

In some DXF files the plasma torch sets down for cut, then moves about lead in arc length without cutting. torch then starts cut and stops cut about lead in length before finishing cut. Works great on most files.