Good morning Les
In sheetcam is there a specific method of identifying which bits are to be cut as opposed to marked, and how do we do this?
Search found 79 matches
- Fri Sep 18, 2015 6:28 am
- Forum: New features
- Topic: Plate marking
- Replies: 4
- Views: 6953
- Thu Sep 17, 2015 2:31 am
- Forum: New features
- Topic: Plate marking
- Replies: 4
- Views: 6953
Plate marking
Good morning all. I have a 4 axis setup from CandCNC (servo DTHC iv ethercut) and was wondering if there is a plate marking (air operated engraver) or something similar to mark plate or eventually rotary jobs. In the post processor it does have the marker as part of the post. Any insights would be g...
- Thu May 07, 2015 11:13 am
- Forum: New features
- Topic: overcut
- Replies: 7
- Views: 8410
overcut
Good morning les
Thankyou for your speedy reply, I do have Version 6.0.15 which does have this function. I have added a 5mm overcut to one of my drawing files, ran the simulator and seems that will fix my problems. I am slowly learning!!!
Thanks again.
Thankyou for your speedy reply, I do have Version 6.0.15 which does have this function. I have added a 5mm overcut to one of my drawing files, ran the simulator and seems that will fix my problems. I am slowly learning!!!
Thanks again.
- Wed May 06, 2015 10:50 pm
- Forum: New features
- Topic: overcut
- Replies: 7
- Views: 8410
Over cut
Good morning Les I am new to your forum, however noticed the topic on overcut. I have been doing some plasma cutting and when the plasma does it's lead in (I set up arc lead in and lead out) there is a small divit left. After reading the overcut topic and seeing this forum topic which states it has ...