sheetcam.com

Hello
It is very interesting, To perform this form as it would be?

I would be very grateful to add that option

I have problem in all the movement should look for the M31 at the height of Z 74,7 mm and not at the height of Z 27,7mm.
The diameter of the tube is 50.8mm

Thanks for your attention . Now I have a little problem in the G code that the postprocessor generates, it's a line that I get over when I'm going to look for the Z axis probe. The postprocessor that I am using is PlasmaRotary Mach3 swapped axes. Can you tell me how I can eliminate it from the postp...

I am using Plasma Rotary Mach3. I have also tried Plasma Rotary Mach3 swapped axes and change the address in Mach3 and the problem is solved, but I would like the rotary complement in sheetcam to work along the Y axis as well. I do not know if it is very complicated to have that option in the rotary...

Hi.
How can I change the position of the X axis to the Y axis?
My machine works along the Y axis but in sheetCam it does not give me the option to change it, it only gives you the option to work in the direction of the X axis.
How can I solve it?

OK
Gracias

Gracias Les por su respuesta pero ya lo había probado pero no funciona debe ser algún problema de SheetCam TNG Development porque si lo abres en SheetCam TNG no da ese error. Thank you Les for your answer but I had already tried it but it does not work it should be some problem of SheetCam TNG Devel...

Este es el trabajo en SheetCam TNG Development

Hola
Me ha surgido este error la importar un DXF al SheetCam TNG Development me ha convertido estas lineas en curvas
Como lo puedo solucionar ?

Hello
I got this error when importing a DXF to the SheetCam TNG Development has turned these lines into curves
How can I solve it ?

Si esto es lo que estaba buscando

Muchas Gracias

If this is what I was looking for

Thank you so much

Mach3 flame with THC-G31

Muchas gracias por su respuesta . Pero realmente lo correcto es como en el dibujo que he adjuntado y creo que a Les no le debe de resultar muy difícil de poner esta opción que seria: 1º Es la altura de iniciación del arco piloto que por ejemplo puede ser 3mm por encima del material . 2º Debería elev...

Hola . Estaría muy bien que en la zona de las herramientas de corte por plasma pusieras la opción para el corte de espesores gruesos la opción de altura inicial del perforado , está sería la que falta que es " altura para que la antorcha se eleve para la salpicaduras del material " y altur...

Hello
I am trying to use Scanything on Mach3 with a Csmio IP-S controller and I am not able to communicate.
What problem can it be?
https://en.cs-lab.eu/product/csmioip-s- ... onnectors/