sheetcam.com

Nevermind I found the setting in the set custom post options tab :/

Man that updated postp did it!!!!!! Thank you! bLouChip!!!!!
I would have never figured it out.

@mancavedweller..I tried it but it did not work.

3 years messing with this machine I am almost were I want to be.

I can move on and be productive. Thanks!!!!

Attached the tap file.
What is a NC file ?

Thank you!

Good day.
I moved the points that was not 0,0...same results.
I changed the pierce delay and nothing.
When I run it in Mach4 it just lifts the z ...cycle thru the code and there it sits
Postp attached, job file attached

Good day. I would like to pierce single points into metal, I reviewed this video > https://www.youtube.com/watch?v=pPwvYN_Hn6s I imported a file with 2 points (use point for drill box selected) created a new jet tool (attached) select a drill operation with the new plasma tool (attached) but the 2 p...

Good day. Trying to figure this out. On my router after the cut has finished it goes to x0, y0 and z0.8" I want to replicate this on the plamsa...I tried parking settings and it will go to x0 and y0 but the torch raises all the way up. parking z will be bypassed in the Mach safe z setting if I ...

Good day.
Question any plans to release scananything for Mach4?

Allot of the things I need to with this would go allot faster.

Tnx.

Thank you!

Good day.
Question...if I have 3 shapes to cut...S1,S2,S3 (attached pic)

Is there a way to skip lets say S2 and only cut S1 and S3? all are one layer.

Good day. 2 question here on starting points...since I am having problems with my plasma..I try to separate the long cuts into smaller cuts until I have everything resolved. Question 1: (Attached pic Startpointquestion.jpeg) I have 3 cutting operations for 3 open curves however it shows only 1 Start...

Thank you!
Works great...one more question on the same subject.
If I have multiple cut operation...let say 12 individual curves.

Is there a way to apply the same rule?

Good day. An unusual question here... When I cut aluminum plate it bends/warps heavily, (I do not have a water table). Is there a way to kind of randomize the cut sequence that it cuts far away of each other as possible? I did it manually but I have to do 60+ cuts and it takes a long time in sheetca...

Nevermind...I can set this in my new Mach4 version.

Good day. After I do a plasma cut with Mach4 and sheetcam the torch retract too high and then go back down again ready for the next cut. Is this a sheetcam setting or Mach4? I found an older post indicating parking however mine has not value. This is what I am looking for at the beginning of the vid...

Got it...changed the colors of the items in cad and it came in with different layers.

Thanks!