Search found 5 matches
- Wed Aug 04, 2021 8:37 pm
- Forum: Problems and questions
- Topic: Plasma is piercing and running sequence but not cutting
- Replies: 7
- Views: 1323
Re: Plasma is piercing and running sequence but not cutting
Les, I figured it out. It was how I was saving the file from Inskape. Once I chose to save it as a .dxf a pop-up "Desktop Cutting Plotter" appears and I changed "Layer export selection" to " Visable only" as opposed to All (default) and the plasma cut out everthing as d...
- Tue Aug 03, 2021 11:23 pm
- Forum: Problems and questions
- Topic: Plasma is piercing and running sequence but not cutting
- Replies: 7
- Views: 1323
Re: Plasma is piercing and running sequence but not cutting
Not sure if that attaches properly, but this would have been the last file I used from Fusion
- Tue Aug 03, 2021 8:05 pm
- Forum: Problems and questions
- Topic: Plasma is piercing and running sequence but not cutting
- Replies: 7
- Views: 1323
Re: Plasma is piercing and running sequence but not cutting
The ground seems to be attached securely. I took it off, cleaned the area and re-attached the ground. Unfortunately there isn't any indicator light on the machine to show that the torch is lit. And I'm using the ViperCut 30i that came with the Langmuir system. Prior to using sheetcam, I had a subscr...
- Tue Aug 03, 2021 1:31 pm
- Forum: Problems and questions
- Topic: Plasma is piercing and running sequence but not cutting
- Replies: 7
- Views: 1323
Re: Plasma is piercing and running sequence but not cutting
Just double checked torch height and had the same issue. I have the Langmuir system and don't have a Z axis so I manually set the height. I even tried cutting with the torch directly on the material and then again with the proper height set and I get the same result. The first time coming out of ink...
- Mon Aug 02, 2021 4:23 pm
- Forum: Problems and questions
- Topic: Plasma is piercing and running sequence but not cutting
- Replies: 7
- Views: 1323
Plasma is piercing and running sequence but not cutting
PHX 2021AWARD.tap I'm having to refresh on sheetcam and have run into an issue I'm sure I'm just overlooking. I created a design in InkSkape and then created the tap file in SheetCam. Everything shows up in Mach3 as it should however when I start the sequence, the torch does its first pierce throug...