sheetcam.com

If you are putting the cut parameters in the plasmac GUI you just need to specify the kerf width. Cut and pierce height can be anything as long as the are below the rapid clearance height (in Options->job options->material). If you want it to behave more like the CandCNC setup you can configure the...

Take a look at this thread https://forum.linuxcnc.org/plasmac/42374-sheetcam-and-trying-to-generate-spotting-gcode?start=40 . The post processor I posted there is probably the best one to use. My only experience with Sheetcam is from CandCNC where everything was configured when I received the PC. I...